Honda Civic Service Manual page 1238

Doors
Latch Replacement
NOTE: Baise the glass fully.
1. Remove:
. Door panel (see page 20-4)
.
Plastic cover (see page 20-2)
. Outer handle (see page 20-5)
Remove the bolt, then move the center lower channel
forwa rd.
Disconnect the connector, and detach the harness
clip from the door. Bemove the latch through the
hole in the door.
NOTE: Take care not to bend the inner handle rod,
outer handle rod, cylinder rod and lock rod.
>: Screw locations, 3
6 x 't.0 mm
8 N.m (0.8 kgt m,
6 tbf.ftl
4. Installation is the reverse of the removal procedure.
NOTE:
.
Make sure the inner handle rod and connector
are connected properly.
. Make sure the door locks and opens properly.
LOCK ROO
20-6
' 1 .
Glass/Regulator Replacement
Removel
o Door panel (see page 20-4)
.
Plastic cover (see page 20-2l,
Carefully move the glass until you can see the bolts,
t h e n r e m o v e t h e m . C a r e f u l l y p u l l t h e g l a s s o u t
through the window slot.
NOTE: Take care not to drop the glass inside the door.
>i Bolt loc.tions,2
f i s ' r . o - .
i
Clb9.8 N.m 11.0 kst m,l
_-l't!!t ,/
GLASS
REGULATOR