Honda Civic Service Manual page 1420

Temperature Control
Adjustment -'96 - 98 Models
1. From under the hood, disconnect the heater valve
cable from the heater valve.
TER
VALVE
CABLE
HEATER VALVE ARM
2 . From under the dash, disconnect the air mix control
cable housing from the cable clamp,
AIR MIX
CONTROL
ARM
3 . Set the temperature control lever to MAX. COOL.
With the air mix control cable attached to the air
m i x c o n t r o l a r m , g e n t l y p u l l o n t h e o u t e r c a b l e
housing to fully close the door and to remove any
s l a c k i n t h e c a b l e . D o n ' t p u l l t o h a r d , o r t h e t e m p e r -
ature control lever will move.
Hold the air mix control arm against the stop. then
s n a p t h e a i r m i x c o n t r o l c a b l e h o u s i n g i n t o t h e
c a b l e c l a m p .
21-44
6.
From under the hood. move the heater valve arm to
t h e f u l l y c l o s e d p o s i t i o n . t h e n a t t a c h t h e h e a t e r
valve cable to the heater valve arm.
7.
Hold the heater valve arm in the closed position,
and gently pull on the heater cable outer housing to
take up any slack. then install the heater valve cable
housing into the cable clamp.
HEATER VALVE ARM