Honda Civic Service Manual page 1103

I
8 .
9 .
Assemble pump rotor to the pump cover with the
" " " marks on the rotor facing down.
Set the 10 vanes in the grooves in the rotor.
NOTE: Be sure that the round ends ot the vanes are
in contact with the sliding surface of the cam ring.
C o a t t h e O - r i n g w i t h p o w e r s t e e r i n g f l u i d , a n d
install it into the grooves in the side plate.
Install the side plate on the cam ring by aligning the
roller set holes in the side plate with the rollers.
mm O-RING
ROLIIR SET HOTT
SET HOI.^E
0 E
g n
1 0 .
1 1 .
r
E
15.2 x 2,1
Replace.
PUMP ROTOR
SIDE PLATE
ROI.I.ERS
l ,
't2.
Coat the O-ring with power steering fluid. and posi
tion it into the pump housing.
Install the pump cover assembly in the pump hous-
t n g .
FI.ANGE EOLTS
20 N.m (2.0 kgf.m,
14 tbf.ft)
PUMP COVER
ASSEMBLY
51 x 2.4 mm
Replace.
C o a t t h e f l o w c o n t r o l v a l v e w i t h p o w e r s t e e r l n g
fluid.
1 5 . l n s t a l l t h e f l o w c o n t r o l v a l v e a n d s p r i n g o n t h e
pump housing.
C o a t t h e O - r i n g w i t h p o w e r s t e e r i n g f l u i d , a n d
install it on the Jlow control valve cap.
Install the flow control valve cap on the pump hous-
't 4.
1 6 .
1 7 .
ing, and tighten it.
{cont'd)
17-45
FLOW CONTROL
VALVE CAP
49 N.m (5.0 kgj m,
36 tbf.ft)