Honda Civic Service Manual page 1273

Uppcr portion:
Lower oortion:
PROTECTIVE
TAPE
l
ADHESIVE
Pillar portion:
Carefully remove the quarter glass
N O T E : C h e c k t h e q u a r t e r g l a s s t r i m a n d c l i p s f o r
damage, and replace them if necessary'
3 .
)
AOHESIVE
TAPE
CLIP
lnstallation
1 . Using a knife, scrape the old adhesive smooth to a
thickness of about 2 mm (0.08 in.) on the bonding
s u r t a c e a r o u n d t h e e n t i r e q u a r t e r g l a s s o p e n i n g
flange.
NOTE:
. Do not scrape down to the painted surface of the
body; damaged paint will interfere with proper
b o n d i n g .
r Remove the rubber dams from the body.
. lf any of the clips are broken, remove them from
the body.
. Mask off surrounding surfaces before applying
p n m e r .
Clean the body bonding surface with a sponge damp-
ened in alcohol.
NOTE: Afier cleaning, keep oil, grease and water
from getting on the surface.
lf the quarter glass is to be reinstalled, use a putty
knife to scrape off all traces of old adhesive. then
clean the quaner glass surface with alcohol where
adhesive is to be apPlied.
NOTE: Make sure the bonding surface is kept free
of water, oil and grease.
CAUTION: Avoid setting the quarter glass on its
edges; small chips may later devglop into cracks.
NOTE: Clean rhe shadowed area.
(cont'd)
20-41