Honda Civic Service Manual page 1270

Rear Window
Installation (cont'd)
Install the fasteners to the hatch as snown.
>: Fastener locations, 4
Set the rear window upright on the hatch, then cen-
ter it in the opening. Make alignment marks across
the rear window and body with a grease pencil at
the four points shown.
NOTE: Be careful not to touch the rear window where
adhesive will be applied.
7. Remove the rear window.
20-38
8 . W i t h a s p o n g e . a p p l y a l i g h t c o a t o f g l a s s p r i m e r
a r o u n d t h e e d g e o f t h e r e a r w i n d o w , t h e n l i g h t l y
wipe it off with gauze or cheesecloth.
NOTE:
. Do nol apply body primer to the rear window,
and do not get body and glass primer sponges
maxed up.
. Never touch the primed surfaces with your hands.
lf you do, the adhesive may not bond to the rear
w i n d o w p r o p e r l y , c a u s i n g a l e a k a f t e r t h e r e a r
window is installed.
.
Keep water, dust, and abrasive materials away
from the primed surface.
RUBBER
DAM
1 5 m m
{0.59 in.l
MOLDING
V/////f , apety st,." o.imer here.
I n s i d e
I
----
- -t-
tUt
I 15mm
| @-
L 10.59 in.l
NJ-l t
r l l \
, z N \
GLASS
\
SPACER
FASTENER
GLASS
REAR WINOOW