Honda Civic Service Manual page 1274

Quarter Glass
Installation (cont'd)
4.
Glue the upper and lower rubber dams to the inside
Iace of the quaner glass, as shown, to contain the
a d h e s i v e d u r i n g i n s t a l l a t i o n .
N O T E : B e c a r e f u l n o t t o t o u c h t h e q u a r t e r g l a s s
where adhesive will be applied.
>: Alignment mark
l o c a t i o n s
GLASS
UPPER
RUBBER DAM
LOWER
RUBEER DAM
Install the quarter glass trim on the quarter glass,
then glue the upper and lower clips as shown.
N O T E : B e c a r e f u l n o t t o t o u c h t h e q u a r t e r g l a s s
where adhesive will be applied.
OUARTER
GLASS TRIM
OUARTER
GLASS
GLASS TRIM
N O T E : C o n t a c t t h e c l j p s a g a i n s t t h e
q u a r t e r g l a s s t r i m a t t h e a r e a s
I n d i c a t e d b y t h e a r r o w s .
UPPER
20-42
6. lf the old quarter glass is to be reinstalled (and the
c l i p o n t h e r e a r e d g e i s b r o k e n o f f ) , a p p l y a l i g h t
coat of primer (3I/ C-100, or equivalent), then apply
butyl tape to the quarter glass, as shown. and seal
the body hole with piece of urethane tape.
N O T E :
. Be careful not to touch the quaner glass where
adhesive will be applied,
. Do not peel the separator offthe butyltape.
//////// '. 8u'Jt tape tocarions t3M 8628, or
equivetenrl
'
Thickness:3.2
mm lo.t3 in.l
Width: 6.4 mm {0.25 in.)
BUTYL
13 mm
TAPE
(0.5 in.l
\
\ l
,7r--/r4--;
*--T-
..
GLASS
UPPER
RUEBER
DAM