Honda Civic Service Manual page 1025

Transmission
Installation
Flush the ATF cooler as described on pages 14-352
and 14-353.
Remove the used grease in the flywheel hub caD
and flywheel splines.
Fill the inside of the flywheel hub cap, and coat the fly-
wheel hub splines with Super High Temp Urea Grease
(P/N 08798 - 9002) as shown.
L
SEALING RING
{RUEBER)
SPLINES
Apply SUPEB HlcH TEMP
UREA GREASE
lPlN 08798 - 90O2t
SUPER HIGH TEMP
UREA GREASE
(P/N 08798 - !)0021
1.5-2.5 g 10.05-0.t9 oz)
I n s t a l l a n e w s e a l i n g r i n g ( r u b b e r ) o n t h e i n o u t
shaft, and install two '14 x 20 mm dowel Dins in the
flywheel housing.
Install the flywheel securely on the input shaft, then
installthe starter motor on the flywheel housing.
4 , 1 N m
la.5 kgt.m, 33 tbt.ft)
INPUT SHAFT
STARTER
l4 x 20 mm DOWEL ptN
.4;i "lrj
,i rr,"r., ., a
14-348
FLYWHEEL
MOUI{T
74 N.m (7.5 tstm,5a tbtftt
6. Place the transmission on s jack, and raise it to the
engine assembly level.
7. Anach the transmission on the engine, then install
the transmission housing mounting bolt and rear
engine mounting bolts.
TRANSMISSION HOUSING
MOUNTING BOIT
6,1 N.m 16.5 kgl.m,
47 tbtttl
59 Nrn {6.0 kgl.m. ,€ lbt ftl
WASHER
lnstall the transmission mount bracket. Tighten the
long bolt loosely, and tighten the nuts and bott on
the mount bracket to the specified torque. Then
tighten the long bolt to the specified torque.
REAR ENGINE MOUNTING
BOLT
Replace.
12 x 1.25 mm
12x 1.25 mn
6,r N'm 16.5 kgtm,47 tbtftl
l-".--..-,^
G \ V
TRANSMISSON
MOUNT BRACKET
12 x 1.25 mn