Honda Civic Service Manual page 1052

I
1 3 . F i t t h e b o o t e n d s o n t o t h e d r i v e s h a f t a n d t h e
outboard joint
Fit the double loop boot bands onto the boot ends'
Pull up the slack in the band by hand'
Mark a position on the band 10
- 14 mm {0 4 - 0 6
in,) from the cliP.
1 4 .
1 6 .
CLIP
l r z
17. Thread the free end of the band through the nose
section of a commercially avaiiable boot band tool
KD-3191 or equivalent and into the slot on the wind-
ing mandrel.
BOOT BAND TOOL
lCommerciallY available)
KD-3191 or equivalent
MANDREL
Place a wrench on the winding mandrel of the boot
band tool, and tighten the band until the marked
spot on the band meets the edge of the clip'
Lift uo the boot band tool to bend the free end of
the band 90" to the clip Center punch the clip, then
fold over the remaining tail onto the clip
Mark spot.
1 8 .
1 q
(cont'd)
16-17