Honda Civic Service Manual page 1211

Diagnostic Trouble Code (DTCI
Diagnostic Trouble Code {DTC) Indication
NOTE: This operation can also be carried out with the Honda pGM
Tesrer.
l
connect the scs service connector to the service check connector inside
the passenger,s side kick panel.
2.
Turn the ignition switch ON (||). but do not start the engine.
NOTE: Do not depress the brake pedal when turning the ignition switch.
3
Record the brinking frequency of the ABS indicator right. The brinking frequency
indicates the DTc.
4, Turn the ignition switch OFF, and remove the SCS service connector.
NorE: The Mslfunction Indicator Lamp (MlL) will stay on after the engine
is started if the scs service connector is
connected.
5. Erase the DTC.
Condhions for DTC indication
. The vehicle is stoDDed.
. The SCS service connector is connected before the ignition switch
is turned ON fll).
. The brake pedal is released.
. Th€ SCS service connector remains connected during this procedure
The DTG indication stops 8nd the ABs conltol unit executes the softwaro
tunqtion if at least one of the following condi-
tions b satisfied:
o The vehicle is not stoDoed.
'
The ABS control unit receives the normat signal (which is for the ABS controt
unit) from a Honda pGM Tester.
. The SCS service connector is disconnected during this procedu.e,
u.s.A.
@
CANADA
@
SERVICE CHECK
CONNECTOR {2PI
SCS SERVICE CONNECTOR
07PAZ - 0010100
ABS INDICATOR LIGHT
DTC : 3 3
A8S INDICAIOR LIGHT
Snilion
swirch
'
when the ignition switch is turned oN (ll), the ABs indicator light comes
on to check the bulb. Do not count it as a DTc.
o The ABS control unit can memorize any number of DTCs.
. The new DTC is not memorized when the ABS control unit has
already memorized the same DTC,
. l f t h e D T C i s n o t m e m o r i z e d , t h e A B S i n d i c a t o r l i g h t s t a y s O N a f t e r i t g o e s o f f f o r 3 . 6 s e c o n d s .
1 9 - 5 6