Honda Civic Service Manual page 1262

Windshield
Installation (cont'd)
Installthe glass brackets and fasteners as shown.
NOTE: The numbers after the part names show the
quantities of the oarts used.
GLASS BRACKETS, 2
Set the windshield on the glass brackets, then cen-
ter it in the opening. Make alignment marks across
the windshield and body with a grease pencil at the
four points shown.
NOTE: Be careful not to touch the windshield where
adhesive will be aDolied.
7 .
8. Remove the windshield.
2 0- 3 0
>: Fastoner locations, 2
FASTENER ^
I
I
SCREW
9. With a sponge, apply a light coat of glass primer
around the edge of the windshield as shown. then
lightly wipe it off with gauze or cheesecloth.
NOTE:
. Do not apply body primer to the windshield. and
do not get body and glass primer sponges mixed
u p .
. Never touch the primed surfaces with your hands.
lf you do. the adhesive may not bond to the wind-
shield properly, causing a leak after the windshield
is installed.
.
Keep water. dust, and abrasrve
from the primed surface.
t/////,
'/////l
I Apply glass p.imer here.
materaals away
Apply glass primer
t o t h e m o l d i n g .
WINDSHIELD
10. With a sponge. apply a light coat of body primer to
the original adhesive remaining around the wind-
shield opening flange. Let the body primer dry for
at least 10 minutes.
NOTE:
. Do not apply glass primer to the body, and be care-
ful not to mix up glass and body primer sponges.
. Never touch the primed surfaces with your hands.
.
Mask off the dashboard before painting the flange.
7////l
/////l
I Apply body p mer hcre.
6 m m
1 6 m m
5 m m
(0.6:| in.)
(0.2 in.l
16 mm
{0,63 in.}
/
MOLDING