Honda Civic Service Manual page 1047

Driveshafts
Reassembly (cont'dl
8.
Fit the inboard joint onto the driveshaft, and note
these items:
.
Reinstall the inboard joint onto the driveshaft by
aligning the marks on the inboard joint with the
marks on the rollers.
.
H o l d t h e d r i v e s h a f t s o t h a t t h e i n b o a r d j o i n t
points up to prevent it from falling off.
Adjust the length of the driveshafts to the figure
below, then adjust the boots to halfway between
full comDression and full extension. The ends of the
boots seat in the groove of the driveshaft and joint.
Right driveshaft, 1600 OOHC VTEC model:
475 - 480 mm (18.7 - 18.9 in)
Left driveshaft, all othei models:
774-779 mm (30.5 - 30.7 in)
Right driveshaft, all other models:
501 - 506 mm 119.7 -'19.9 inl
Left driveshaft. 1600 DOHC WEC model:
475 - 480 mm 118.7 - 18,9 inl
16 -1 2
OYNAMIC DAMPER
OUTBOARD JOINT
10. lf necessary position the dynamic damper as shown
Detow.
. Install a new dynamic damper band. and bend
down both sets of locking tabs.
. Lightly tap on the doubled-over ponjon of the
band to reduce its height.
Loft:
1600 DOHC VTEC model: 26 i 2 mm (1.0 t 0.1 inl
All other models:
9,1t 2 mm (3.7 10.1 inl
With "SR1" mark:
7512 mm 12.9 ! 0.1 inl
Right:
16dl DOHC VTEC models: 2612 mm 11.0 t 0.1 inl
All other modelii
DYNAMIC DAMPER
-SR1" MARK
U.S. and Canada-Produced ITPE BOOTI
Left 53612 mm {21.1 10.1 in}
Right: 2txt 12 mm {10.it 1 0.1 in}
5 5 1 2 m m ( 2 . 2 t 0 . 1 i n l
INBOARO JOINT
DYNAMIC DAMPER BAND