Honda Civic Service Manual page 1275

t
l
7.
With a sponge, apply a light coat of glass primer to
the inside face of the quarter glass, as shown, then
lightly wipe it off with gauze or cheesecloth.
N O T E :
. Do not apply body primer to the quarter glass,
and do not get body and glass primer sponges
m i x e d u p .
. Never touch the primed surfaces with your hands.
lf you do, the adhesive may not bond to the quar
ter glass properly, causing a leak after the quar-
ter glass is installed.
. Keep water, dust, and abrasive materials away
from the primed surface.
////////l : ^pptv stass primer he.e.
2 1 m m 1 5 m m
{0.83 in.) (0.59 in.)
UPPER
RUBBER
DAM
BUBBEB
DAM
OUARTER GLASS
1 5 m m
10.59 in.l
30 mm
(r.2 in.)
)
8. With a sponge, apply a light coat of body primer to
the original adhesive remaining around the quarter
glass opening flange. Let the body primer dry for at
least 10 minutes.
NOTE:
. Do not apply glass primer lo the body, and be
c a r e f u l n o t t o m i x u p g l a s s a n d b o d y p r i m e r
sponges.
.
Never touch the primed surfaces wilh your hands.
.
Mask off the rear side trim panel before painting
t h e f l a n g e .
/////////
| apetl body erimer he,e.
16 mm
{0.63 in.l
Thoroughly mix the adhesive and hardener together
on a glass or metal plate with a pufty knife.
NOTE:
. Clean the plate with a sponge and alcohol before
m r x l n g .
. Follow the instructions that came with the adhe-
s i v e .
Before filling a cartridge, cut the end of the nozzle
as shown.
C u t n o z z l e e n d
10 mm (0.39 in.l
(cont'd)
9 .
1 0 .
7 mm (0.27 in.)
20-43