Honda Civic Service Manual page 1106

Steering Gearbox
Removal {cont'dl
Loosen the 14 mm flare nut and disconnect the feed
l i n e .
Loosen the adjustable hose clamp and disconnect
the return hose.
Loosen the 16 mm flare nut and remove the return
hose joint trom the valve body unit.
CAUTION: After disconnecting lhe hos6 and lin6.
plug or seal the hose and line with a pioca ol tapa
or equivalent to prevenl foreign matorials trom
entsring the valve body unit.
N O T E : D o n o t l o o s e n t h e c v l i n d e r l i n e A a n d
between the valve body unit and cylinder.
ADJUSTABLE HOSE
CLAMP
Remove the stiffener Dlate.
NOTE: Some stiffener plate attaching bolts are also
used as gearbox mounting bolts. The gearbox will
tilt to side when these bolts are removed.
1 3 .
1 4 .
t 9 .
1 6 .
17-48,
17. Remove the mounting brackets.
Pull the steering gearbox all the way down to clear
the pinion shaft from the bulkhead. then remove the
pinion shaft grommet.
Move the steering gesrbox to right so the left rack
end clears the rear beam, then tilt the left side down
to remove it from the vehicle,
CAUTION: Be careful not io bend or damage the
fagd ling and cylindsr lin99 whgn rgmoving thg
ggarbox,
1 8 .
STEERING GEANEOX