Honda Civic Service Manual page 1319

5.
Installation is the reverse of the removal procedure.
NOTE:
. Check that the retractor locking mechanism func-
tions as described on page 20-91.
. Make sure you assemble the washers and collars
on the uoDer and lower anchor bolts as shown.
. Before installing the anchor bolts, make sure there
are no twists or kinks in the front seat belt.
SPRING
WASHER
Lower anchor bolt construction:
S P R I N G
WASHER
BUSHING
BUSHING
COLLARS
LOCKWASHER
ANCHOR
Reiractor bolt construction:
TOOTHEO
LOCK WASHER
WASHERS LowER
LOWER ANCHOR
BOLT
RETRACTOB
Seat belt buckle removal:
1 . R e m o v e t h e f r o n t s e a t t h r o u g h t h e d o o r o p e n i n g
{see page 20-74).
2.
Remove the center cover (see pages 20-75,76).
3. Remove the center anchor bolt, then remove the seat
belt buckle.
SEAT BELT
BUCKLE
ANCHOR BOLT
INNER SEAT
TRACK
TOOTHEO
LOCK WASHER
SPRING
WASHER
HARNESS 7/16.20 UNF
CLIP
32 N m (3.3 kgt m, 24 lbf'ft)
4.
Driver's: Detach the seat belt switch connector and
harness clip from the seat cushion (see page 20 77).
Remove the seat cushion mounting bolts from the
inner seat track {see page 20-75), and move the inner
seat track, then pull the seat belt switch harness out.
NOTE: Take care not to damage the hinge bracket.
Centsr anchor bolt construction:
CENTER ANCHOR
BOLT
WASHER
Installation is the reverse of the removal procedure.
NOTE: Make sure you assemble the washers and
bearing on the center anchor bolt as shown.
20-47