Honda Civic Service Manual page 1046

lnboard Joint Side:
1, Wrap the splines with vinyl tape to prevent damage
to the boots and dynamic damPer.
TAPE
INBOARD BOOT
DYNAMIC DAMPER
Install the dynamic damper and inboard boot to the
driveshaft, then remove the vinyl tape. Take care
not to damage the boots.
I n s t a l l t h e s t o p r i n g i n t o t h e d r i v e s h a f t g r o o v e
(Applicsble to '96 - 98 models and Brazil - Produced
d r i v e s h a f t s ) . A l w a y s r o t a t e t h e s t o p r i n g i n i t s
groove to be sure it is fully seated.
@--c't"t't
STOP RING
(ApplicablG to'96- 98 modob and
Brrzil-Producrd drivoshaftrl
Install the spiiler on the driveshaft by aligning the
marks on the sDider and the end of the driveshaft.
Fit the circlip into the driveshaft groove. Always
rotate the circlip in its groove to be sure it is fully
seated.
VINYL
-
-\r/
-<@
l r ;
6.
Fit the rollers onto the spider with their high shoul-
ders facing outward, and note these items:
.
Reinstall the rollers in their original positions on
the spider by aligning the marks
. Hold the driveshaft pointed up to prevent the
rollers from falling off.
Pack the inboard joint with the joint grease included
in the new driveshaft set.
Grease quantity:
Japan-Produced:
1600 DOHC VTEC ongine:
130 - 1/t0 g 14.6 - '[.9 oz)
Except 1600 DOHC VTEC angine:
110 - 120 I {3'9 - il'2 oz}
Left inboard ioint splines O:
0'5 - 1.0 s (0.018 - 0'035 oz)
U.S,, Canada, and Brazil'Produced:
1 1 5 - 1 3 5 g ( 4 0 - 4 . 8 o z l
7 .
6
-6.l
(cont'd)
1 6 - 1 1
High shoulder faces