Honda Civic Service Manual page 1278

Ouarter Glass
1 .
Installation
Using a knife, scrape the old adhesive smooth to a
thickness of about 2 mm (0.08 in.) on the bonding
s u r f a c e a r o u n d t h e e n t i r e q u a r t e r g l a s s o p e n i n g
flange.
NOTE:
.
Do not scrape down to the painted surface of the
body; damaged paint will interfere with proper
a
a
bonding.
Remove the fastener from the body.
lf any of the clips are broken, remove lhem from
the body.
Mask off surrounding surfaces before applying
pnmer.
Clean the body bonding surface with a sponge damp
ened in alcohol.
NOTE: After cleaning, keep oil, grease and water
from getting on the surface.
lf the quarter glass is to be reinstalled, use a putty
knife to scrape off all traces of old adhesive. then
clean the quarter glass surface with alcohol where
adhesive is to be applied.
NOTE: Make sure the bonding surface is kept free
of water. oil and grease.
CAUTION: Avoid setting the quarter glass on its
odges; small chips may later develop into cracks,
NOTE: Clean the shadowed area.
20-46
4. Install the molding around the edge of the quarter
glass as shown.
NOTE:
. lf the old molding is to be reinstalled, scrape off
t h e o l d a d h e s i v e t a p e f r o m t h e m o l d i n g , a n d
c l e a n t h e m o l d i n g s u r f a c e w i t h a l c o h o l w h e r e
new adhesive tape is to be applied. Apply the
double-faced adhesive tape to the molding and
quarter glass as shown.
.
Be careful not to touch the quarter glass where
adhesive will be aoDlied.
Adhesiv€ tspe A (3M 4215, or equivalent)
Thicknsss: o.il mm (0.02 in.l
Widih: 5 mm {0.2 in.}
Length: /140 mm {17.3 in.)
Adhesive tap6 I (NITTO 501, or equivatontl
Thickness: 0.16 mm {0.006 in.)
Width: I mm {0.3 in.}
Longlh: 4it0 mm (17.3 in.)
Adhosiv€ tape C (3M /P13. or equivalentl
Thickness: 0.8 mm (0.03 in.l
Width: 5 mm (0.2 in.)
Length: 30 mm (1.2 in.)
ADHESIVE