Honda Civic Service Manual page 1098

Power Steering Pump
RemovaUlnstallation
NOTE: Eefore disconnecting the hoses from the pump,
Dlace a suitable container under the vehicle.
1. Remove the belt by loosening the pump mounting
b o l t s a n d a d j u s t i n g b o l t ( ' 9 9 - ' 0 0 m o d e l s : 8 1 6 4 2
Engine Type only).
OUTLET LINE
11 N.m {1.1 kgf'm,
8
L
PUMP MOUNTING BOLT
24 N.m (2.4 kgl.m, 17 lbf ft)
2.
Cover the Ay'C compressor with several shop towels
to protect it from spilled power steering fluid.
3.
Disconnect the inlet hose and the outlet line from
the pump, and plug them.
NOTE: Take care not to spill the fluid on the body
or parts, Wipe off any spilled fluid at once.
4 . R e m o v e t h e p u m p m o u n t i n g b o l t s a n d a d j u s t i n g
b o l t ( ' 9 9 - ' 0 0 m o d e l s : 8 1 6 A 2 E n g i n e T y p e o n l y ) ,
then remove the pump.
NOTE:
.
Do not turn the steering wheel with the pump
removeo.
. Wrap the opening of the pump with a piece of
tape to prevent foreign material from entering
t h e p u m p .
17-40
1 .
8.
Connect the inlet hose and the outlet line. Tiqhten
the pump fittings securely.
Loosely install the pump in the pump bracket with
mounting bolts and adjusting bolt ('99 -'00 models:
81642 Engine Type only).
Installthe pump belt.
CAUTION:
. Make sure that the power steering belt is prop-
orly positioned on the pulleys.
. Do not get power stoering tluid or grease in the
power steering bsh or pulley faces. Clean off any
fluid or grease before installrtion.
Adjust the pump belt (see page 17-32).
Fill the reservoir to the upper level line (see page