Steering Gearbox
Reassembly (cont'd)
SLEEVE SEAL RINGS
Replace.
8e sure that the
seal nngs are not
turned up, then
insta ll.
21. Apply vinyl tape to the pinion shaft. then coat the
vinyltape with power steering fluid.
Sealing lip face.
VALVE OIL SEAL
VALVE HOUSING
Press the new bearing ('96 - '97 models) or new
bushing ('98 -'00 models) into the valve housing
using a hydraulic press and special tool as shown,
NOTE: Place the roller bearing ('96 -'97 models) on
the valve housing with the stamped letter facing up
towards the valve side.
DRIVER
077itg-001tXlOO
22. Insert the pinion shaft into the valve housino.
CAUTION: Be careful noi to damage th€ valve seal
rings.
23. Remove the vinyltape from the pinion shaft.
20.
Pr033
+
3 : I x 3 5 m m
07746 - 0010,t(x)
'96 - '97 models:
ROLLER BEARING
Letter stamped tace
upward.
ATTACHMENT,
'98 - '00 modob:
?/_vusHrNG
['---v-lt
\ 4 )
PINION
E
17-5A
2 4 . P r e s s t h e p i n i o n s h a f t / s l e e v e u s i n g a h y d r a u l i c
press as shown.
N O T E : C h e c k t h a t t h e p i n i o n s h a f v s l e e v e t u r n s
smoothly by turning the pinion shaft.