Honda Civic Service Manual page 1359

Front Seat Belt
RemovaUlnstallation
2D l3Dl
1. Slide the front seat forward fully.
2. Remove:
. Rear seat-back and rear seat cushion (see pages
20-126,127l.
. R e a r c e n t e r s h e l f a n d r e a r s i d e s h e l f ( 3 D , s e e
page 20-60)
.
Resr trim panel (3D, see page 2G60)
. Side trim panel (see pages 20-60, 61)
3. Pull back the carpet as necessary, and remove the
bolts, then remove the middle floor gusset.
>: Boh locations,8
10 x 1.25 mm
38 N.m (3.9 kgf'm,
28 rbtftl
20-124
4. Remove the upper anchor cover and lower anchor
cap.
UPPER ANCHOR EOLT
7/16-20 UNF
32 N.m {3.3 kgf.m,
24 tbf.ftt
UPPER ANCHOR
COVER
LOWER
ANCHOB
CAP
I
I
i
o
RETRACTOR
MOUNTING BOLT
6 x 1 . 0 m m
9.8 N.m (1.0 kgf.m.
7.2 tbl.hl
LOWER ANCHOR BOLT
7/16-20 UNF
32 N.m (3.3 kgt.m, 24 lbf.ft)
Remove all the anchor bolts and the retractor bolt.
remove the retractor mounting bolt, then remove the
Iront seat belt and retractor.
Installation is the reverse of the removal orocedure.
NOTE:
. Check that the retractor locking mechanism func-
tions as described on page 20-91
o Make suri vou assemble the washers and collars
on the upper and lower anchor bolts as shown.
.
Before installing the anchor bolts, make sure there
are no twists or kinks in the front seat belt.
RETRACTOR AOLT
7/16-20 UNF
32 N.m 13.3 kgf.m,
24 tbttrl
6.