Honda Civic Service Manual page 1348

Washer Tube
Replacement
NOTE:
. To remove the windshield washer tube, remove the
left inner fender (see page 20-106),
. To remove the rear window washer tube {3D), remove
the following parts from the left side of the vehicle.
-
Inner fender (see page 20-106)
-
Kick panel and side trim (see page 20-60)
-
Rear seat-back and rear seat cushion (see page 20-
80)
- Spare tire lid
-
Rear center shelf and rear side shelf (see page 20-
60)
-
Rear trim panel and side trim panel
60)
Ouarter trim panel (see page 20-60)
-
Rear roof trim {see page 20-65)
- Hatch spoiler (see page 20-101)
(see page 20
WIRE
HARNESS
>: W.sher nozzle, clip and cushion locations
a > , 2
B > , 3
"J>)
[q
@"
F > , 1 1
c > , 1
wttrtosnteLo 6}
usxea =-d
lNozzrE cv
i q
! $ e
D > , 1 E > , 1
NtW)€
Roote the washer tube
under the wire harness.
TUBE
A
Route the washer tubes
to the washer reservoir
REAB WINDOW
WASHER TUBE
( I o r s o m e m o d e l s )
REAR WINDOW
WASHER TUBE
washer nozzle.
washer nozzle
(see page 20-101).
oo\
Installation is the reverse of the removal procedure.
NOTE:
. Take care not to pinch the washer tubes.
. lf necessary, replace any damaged clips.
. After installing, adjust the aim of the washer noz-
zles (see page 20-117).
2 0 - 1 1 6
WINDSHIELD