Honda Civic Service Manual page 1460

Compressor {SANDEN)
Clutch Overhaul
1. Remove the center nut while holding the armature
plate with the tool.
CENTER NUT
17.6 N.m {1.8 kg{.m,'t3 tbnft}
2.
Remove the armature plate by pulling it up by hand.
ARMATURE PLATE
A/C CLUTCH HOLDER
{Commerciallv aveilable)
Robinair: P/N 10204
Kent-Moore: P/N J37872
22-34
3. Remove snap ring B with snap ring pliers.
NOTE:
.
Be careful not to damage the rotor pulley and
compressor during removal/installation.
. Once snap ring B is removed, replace it with a
new one.
A
\ /
G::.
Remove the rotor pulley from the shaft with a puller
and the special tool.
NOTE: Place the claws of the puller on the back of
the rotor pulley, not on the belt area; otherwise the
rotor pulley can be damaged.
. r\t \\:g2rl
-/
/
. - ! L ; j ' /
TWO JAW PULLER
{Commercially