Assigning Trunk, Ip Trunk, & Route Access - Altigen Altiware OE 4.5 System Administration & Installation Manual

Setting a System Number Plan
Parameter
Description
DID Number The number of digits needed to match a DID (Direct Inward
Length Dialing) number, with a range of 2 - 16.
Each extension can be assigned a DID number. A DID
number does not have a fixed length. For example, the DID
number length is 4; the extension DID number - 2529299.
Depending on the service contract with the Central Office
(CO), the DID trunk can send all 7 digits (2522999) or just
the last 4 digits (2999). If this DID Number Length option
is set to 4, the system always tries to match the last 4 digits
received to the last 4 digits of a DID number, regardless of
what is received.
Note: To accommodate future growth and minimize
disturbance, it is recommended that the length of the DID
numbers assigned to an extension be greater than or equal to
this DID Number Length. However, it is not necessary to
use the DID Number Length when routing via tie trunks.
First Digit These define how the system responds to the first digit
Assignment dialed by the user. If a particular digit is grayed out—not
available—that means it cannot be used in the country
location selected in the General window.
The drop-down list options for each digit are as follows:
—
—
—
—
—
—
Assigning Trunk, IP Trunk, & Route Access
You can use trunk, IP trunk, and route access outgoing call options alone
or in combination when making the number plan assignments.
106 AltiWare OE System Installation & Administration Manual
Extension
Trunk Access
Operator
Invalid (no action)
IP Trunk Access
Route Access