Table of Contents
Advertisement
System Configuration
Assigning Trunk, IP Trunk, & Route Access
You can use trunk, IP trunk, and route access outgoing call options alone
or in combination when making the number plan assignments.
Trunk Access
Usually, 9 is used as the analog or PSTN trunk access code, and AltiWare
uses 9 as the default for trunk access. You can keep that configuration and
assign other digits such as 7 or 8 to Route Access and IP trunk access, or
you can change it. There are no defaults for IP trunk or Route Access.
IP Trunk Access
Only one IP trunk access option is allowed per AltiWare system. It is highly
recommended that the same IP trunk access code (e.g. 8) is used for all
AltiWare systems in the network. To use Voice over IP, you need to set up
this access and, in addition, configure the IP Dialing Table as discussed on
page 41.
Route Access
The Route Access option can be assigned to one or more digits, to route the
call per the out call routing table. Out call routing, which is sometimes
called ARS (Automatic Route Selection) or LCR (Lease Cost Routing
without carrier rate table), is described in "Out Call Routing
Configuration" on page 121.
Out call routing is designed to help 10 digit dialing, zoomerang dialing,
digit manipulation, and tie trunk hop-off dialing.
W h e n m a k in g o r e d itin g th e se o r o th e r n u m b e r p la n
a ssig n m e n ts, p le a se re fe r to th e c o n sid e ra tio n s o n se ttin g a n d
e d itin g d isc u sse d o n page 24.
26 AltiWare OE System Administration Manual
Advertisement
Table of Contents
