Table of Contents
Advertisement
•
Select and give your ISP a unique Domain Name. Each domain
must have a unique name associated with it, such as the address for
AltiGen, which is "altigen.com".
• Obtain a Block of IP Addresses and assign a unique IP address to
each client on the LAN.
• Obtain the Subnet Mask. You will need to enter this address later
in the TCP/IP configuration setup for both the server and client
stations.
Step 2: Setup the Router
Install the router on the LAN. The router is the gateway to another LAN or
to the Internet.
1.
Specify a router that is on the same LAN as the AltiServ server, such
as ISDN or T1.
2.
Assign an IP address (one of the block of IP addresses obtained from
the ISP to the router). This becomes the gateway router address.
Step 3: Configure TCP/IP Properties
Configure the TCP/IP protocol parameters.
1.
Open the Control Panel and select the Network icon. The Network
Setting window is displayed.
Figure 1. Network Setting window
AltiWare OE System Installation & Administration Manual
Data and Internet Integration
271
Advertisement
Table of Contents
Troubleshooting
