Table of Contents
Advertisement
Setting Answering Options
A One Hop Limit to Call Forwarding for a Transferred Call
There is a one hop limit to call forwarding when the call that is being passed
is a transferred call. For example, extension 100 receives a transferred call
and forwards this call to extension 101; extension 101 is set to forward all
calls to extension 102; extension 102 receives the call but CANNOT
forward this call to another extension.
A 10-Hop Limit to Call Forwarding for Direct Calls
For direct calls, there is a "10-hop" limit to call forwarding. For example,
extension 100 forwards to extension 101, 101 forwards to 102, 102
forwards to 103, and etc. through extension 120. A call to extension 100
will be forwarded to 101, which will forward to 102, which will forward to
103, and etc. until the call has been forwarded 10 times. At this point, the
call will not be forwarded again; if the last extension in the forwarding
chain does not answer, the call is sent to extension 100's voice mail.
If there is a loop condition in the forwarding chain (for example, 100
forwards to 101, 101 to 102, and 102 back to 100), the call is sent to the first
destination's voice mail.
To enable call forwarding, select the Enable Call Forward to check box,
then, using the drop-down list, indicate the forwarding destination. You can
use Apply to... to act on multiple extensions, with the restrictions
discussed in the previous section. The forwarding options are as follows:
•
To Voice Mail
•
To an Auto Attendant—select the Auto Attendant number to use in
the drop-down list under the option. Auto Attendant settings are
established in Auto Attendant Select... on the Management menu.
•
To an Extension—select an extension from the drop-down list.
•
To an Outside Number—this option is available if it is allowed in the
Other Call Restrictions option in the Restriction window, as
discussed in "Setting Other Call Restrictions" on page 220. Also, see
"Outcall to Cellular or PCS Phone Numbers" on page 217.
If you choose Outside Number, select a trunk or route access code to
use in the small drop-down list on the left, and type in the full prefix
and phone number.
•
To the Operator
222 AltiWare OE System Installation & Administration Manual
Advertisement
Table of Contents
Troubleshooting
