Establishing Basic Extension Attributes - Altigen Altiware OE 4.5 System Administration & Installation Manual

2. Type in an Extension Number.
The number must begin with a number assigned to be used for exten-
sion, and it must be the length assigned to extensions, both of which
are set in the Number Plan in System Configuration as described in
"Setting a System Number Plan" on page 104.
3. Select the Type of extension from the three options, Physical, Virtual,
or Workgroup Pilot.
Note: See the discussion of the different extension types on page 189.
Note also that after the extension is created, you can change
Virtual extensions to Physical, and vice versa, but you cannot
change Physical or Virtual to Workgroup pilot or vice versa.
The Physical Extension License displays the maximum number of
physical channels licensed to the user as well as the number of
assigned, licensed physical channels.
4. Depending on the type of extension you're creating, take one of the
following actions:
• If you're setting a virtual or workgroup pilot number, you're done.
Click OK.
• If you're setting up a physical extension, select an available
physical location—slot and channel for the line—then click OK.
The slots (the location of the board in the PC) and the channels
(the ports) are displayed and available if they have not yet been
assigned to an extension.

Establishing Basic Extension Attributes

After you create an extension, you can set other basic attributes in the
Extension Configuration General window:
To set the Personal Information:
Type in the User Name, Password, DID, Tenant Group, and optional
Description:
• First Name and Last Name of the extension user, each with a
maximum of 32 characters.
• Password for the extension user. The default is the system default
password set on the Number Plan tab of the System Configuration
window.
AltiWare OE System Installation & Administration Manual
Extension and Workgroup Configuration
193