Altigen Altiware OE 4.5 System Administration & Installation Manual page 172

Use the Board Configuration window for the Quantum board to view the
following attributes:
Parameter
Board Info
Channel Mapping
List
Span Info
Board Configuration
AltiWare OE System Installation & Administration Manual
Description
Board Logical ID: assigned by AltiServ.
Board Name: the type of board installed in the
system and board ID.
Note: For Quantum boards in a Windows 2000
system:
•
the physical board ID 0 is not supported
•
the valid physical board IDs are 1–15
Logical Channel, Physical Span, and Physical
Channel for the entire board.
To reset the channel, select the channel to reset and
click the Reset Channel button, then click OK.
Note: Depending on whether the channel is a line or
a trunk line, double clicking a channel in this
window invokes either a Line Properties
window (see "Quantum Line Properties" on
page 200, or a Trunk Line Properties window
(see "Quantum Trunk Properties" on page
176).
Not available for Quantum boards.
Opens a diagnostic dialog box.
Figure 3. Quantum Board Debug
You can send a debug string to the board, or you can
do a DSP Dump, Memory Dump, or FMIC Dump.
Board Configuration
143