Operating Procedure - Brother BAS-761 Instruction Manual

Chapter 5 Practical programming examples

Operating procedure

1
Programming
1. Press .
P
The work clamp comes down and the programmer screen is displayed.
2. Move the needle with
the needle point is at point A of the pattern.
The first stitch (point A) is programmed.
3. Input the stitch length.
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
4. Press .
LI LI
5. Move the needle with
the needle point is at point B of the pattern.
6. Repeat steps 4 and 5 and create the program to
point E.
7. Input the number of stitches to return the needle
to the position where two row switch is input,
then press
5 is input in the example. The needle moves 5 stitches back.
8. Press
8 1
The screen to set the attributes appear and two row switch is set.
9. Input the number of stitches to proceed the
needle to point E, then press
5 is input in the example. The needle moves 5 stitches ahead.
10. Press
9
is a command for needle tacking. Input the stitch length
9
in . 0.5 mm is input in the example.
142
. Press
. Press
.
, then press .
0
L
.
, then press .
LI LI
when
L
when
L
Programmer