Needle Racking - Brother BAS-761 Instruction Manual

Needle racking

Zigzag
width
Stitch length
Tacking width is set with the dial on the back of the top part of
the machine while needle tacking length is set with the
programmer. Values 1.0 to 3.5 mm are available for the tacking
width.
Values 0.1 to 1.0 mm are available for the stitch length.
The needle actually drops at the point B' because needle tacking is conducted on the machine side. However, point
B of the program is created on the straight line between point A and point C.
1
Programming
1. Create the program to point A.
2. Move the needle with
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
3. Press
9
is the command for the tacking. Input the width of
9
the tacking in
4. Move the neddle with
when the needle point is at point C of the
pattern.
5. Continue programming.
. Press
, then press .
M
. 0.5 mm is input in the example.
. Press
Chaprter 3 Programming with Command Function
Needle tacking is programmed.
L
L
Programmer 91