Operating Procedure - Brother KE-484C Instruction Manual

5. OPERATION

5-2. Operating procedure

Preparation
Turn on the power switch.
* The POWER indicator (1) will illuminate and the
program number will flash in the display window (14).
Note when creating additional data
When sewing data with a small number of stitches (15 stitches or less) is sewn repeatedly (short cycle operation), the
upper shaft motor may overheat and the "E-20" error code may be generated.
5-2-1. Setting the program number
Press the SELECT switch (6)
1
until the PROGRAM NO. in-
dicator illuminates.
5-2-2. Setting the X-scale and Y-scale
Press the SELECT switch (6)
1
until the X-scale or Y-scale
indicator illuminates.
Note:
* Be sure to check the sewing pattern (refer to page 24) after setting has been completed to make sure that the needle hole
does not go out of the area circumscribed by the work clamp.
* The needle racking width for backtack stitches (with stitch widths of 1 mm or less) is not enlarged or reduced. If this results
in problems, set memo-0d to "ON" to enlarge or reduce the needle racking width for backtack stitches.
21
Press
2
switches (12) until the desired
program number is flashing in
the display window.
2516Q
Press
2
switches (12) until the desired
scale setting is flashing in the
display window.
(The setting is displayed as a per-
centage.)
2518Q 2519Q
KE-484C
Factory default
Program No.
X-scale (%)
Y-scale (%)
Speed (rpm)
*1 For checking the origin points for X and Y feed
*2 Custom-made program
the DISPLAY SET
2602Q
the DISPLAY SET
Variable range
0 100-
* 1 * 2
100 20 - 200
100 20 - 200
2,000 1,000 - 2,200
Depress the work clamp switch
3
to lower the work clamp, and
depress the start switch.
The display will stop flashing and
illuminates steadily,
mechanism will move to the sewing start
position.
This completes the setting of the program
number.
Depress the work clamp switch
3
to lower the work clamp, and
depress the start switch.
The display will stop flashing and
illuminates steadily,
mechanism will move to the sewing start
position.
This completes the setting of the X-scale or Y-
scale.
and the feed
3165Q
and the feed
3165Q