Brother BAS-761 Instruction Manual page 88

2. Move the needle with
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
3. Input the stitch length, then press
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
4. Move the needle with
when the needle point is at point B of the
pattern.
5. Repeat step 4 and create the program to
point D.
6. Move the needle with
when the needle point is at point
7 8 9 L
E of the pattern.
Point E becomes a sharp corner.
7. Press .
M
To change the stitch length, specify the pitch value before
pressing .
M
8. Repeat step 4 and create the program from
points F to H.
9. Press
8
7
The range from points C to E is programmed.
2
Inputting the end code
1. Press
1 1
The needle returns to the sewing start position.
3
Saving
1. Specify the program number on the
operation panel, then press
writing into the floppy disk.
Refer to "Using the operation panel of the main body"(page 131)
for detailed operation.
. Press
. Press
as in step 6 at point I.
9 L
.
1 E
Chaprter 3 Programming with Command Function
L
.
M
L
. Press
switch for
Programmer 87