Brother BAS-761 Instruction Manual page 149

Chapter 5 Practical programming examples
33. Move the needle with
the needle point is at point O of the pattern.
34. When point O is programmed, press
35. Select with
36. Press .
37. Move the needle with
the needle point is at point P of the pattern.
38. Repeat step 37 and create the program to point
T.
39. When point T is programmed, press
Point T is programmed to be a corner. To change the stitch length,
press to set it again.
ESC ESC
40. Create the program to point Y.
41. When point Y is programmed, press
42. Press twice.
ESC ESC
43. Select with
44. Press .
45. Move the needle with
the needle point is at point Z of the pattern.
148
. Press when
twice.
ESC ESC
, then press .
. Press when
again.
again.
, then press .
. Press when
Programmer