Changing Partially - Brother BAS-761 Instruction Manual

If the stitch length is 0.0, the pattern is resized with the same
number of stitches as the original data.
3
Saving
1. Specify the program number on the operation
panel, then press
floppy disk.
Refer to "Using the operation panel of the main body"(page 131)
for detailed operation.
4
Ending program
1. Press .
P

Changing partially

1
Calling data
1. Specify the program number on the operation
panel, then press
Refer to "Using the operation panel of the main body"(page 128)
for detailed operation.
2
Moving to position 4
1. Press
9
9
The work clamp comes down and the programmer screen is
displayed.
2. When the needle point reaches 4, press
The needle stops. If the needle passes, input a few stitches and
press . The needle returns for a few stitches of the input.
3
Programming a new point
switch for writing into the
switch to read the data.
, then press .
9
Chaprter 3 Programming with Command Function
A part of the programmed pattern is changed. The
example in the left is used for explanation of creating 5',
6' and 7'.
.
Programmer 93