Brother BAS-761 Instruction Manual page 150

46. When point Z is programmed, press
47. Select with
48. Input the stitch length of needle tacking, then
press .
0.5 mm is input in the example.
Input 005 to make the stitch length to 0.5 mm.
49. Move the needle with
the needle point is at point A of the pattern
50. Press twice.
ESC ESC
2
Input the end code
1. Select with
2. Press .
The needle goes back to the sewing start position and the retractable
clamp is positioned outside.
twice.
ESC ESC
, then press .
. Press when
, then press .
Programmer
Chapter 5 Practical programming examples
149