Example Of Modified Program; Resizing Pattern - Brother BAS-761 Instruction Manual

Chapter 3 Programming with Command Function

Example of modified program

This section describes the modification method of the program using examples. Refer to "Programming" (page
105) .

Resizing pattern

The center point (reference point) of resizing is as follows.
X coordinate : Center of the outer shape of the data
Y coordinate : Uppermost position of the data
Resizing scale between 90 to 110 % are available.
All the settings of attributes become invalid if the pattern is resized without changing the stitch length. Set the
attributes after resizing the pattern.
1
Calling data
1. Specify the program number on the operation
panel, then press
Refer to "Using the operation panel of the main body"(page 128)
for detailed operation.
2
Resizing
1. Press
8 8
Input the resizing command.
2. Press
0 9
Input the resizing percentage for the X axis. Specify the
magnification percentage by 3 digits in
is specified in the example.
3. Press
0 9
Input the resizing percentage for the Y axis. Specify the
magnification percentage by 3 digits in
is specified in the example.
4. Input the stitch length, then press
92
Reference point
switch to read the data.
, then press .
M
8
, then press .
F
0
, then press .
M
0
The programmed pattern is resized. The example in the
left is used for explanation.
. 90%
. 90%
.
L
Programmer