Brother BAS-761 Instruction Manual page 141

Chapter 5 Practical programming examples
21. Input the stitch length, then press
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
22. Move the needle with
the needle point is at point G of the pattern.
23. Repeat step 22 and create the program to point
J.
24. When point J is programmed, press
25. Select with
26. Input the stitch length of needle tacking, then
press .
0.5 mm is input in the example.
Input 005 to make the stitch length to 0.5 mm.
27. Move the needle with
the needle point is at point A of the pattern.
28. Press twice.
ESC ESC
2
Input the end code
1. Select with
2. Press .
The needle goes back to the sewing start position and the retractable
clamp is positioned outside.
140
.
. Press when
twice.
ESC ESC
, then press .
. Press when
, then press .
Programmer