Curve - Brother BAS-761 Instruction Manual

Chapter 3 Programming with Command Function
3
Saving
1. Specify the program number on the
operation panel, then press
writing into the floppy disk.
Refer to "Using the operation panel of the main body"(page 131)
for detailed operation.
4
Ending program
1. Press .
P

Curve

Be sure to press
7 8
When a split is made
More intermediate points such as points B, D, F, G or H will create smooth curves.
1
Programming
1. Press .
P
The work clamp comes down and the programmer screen is
displayed.
86
for a split at corner point E. If a split is not made, the corner will be round.
9 L
switch for
A pattern with curves is programmed.
When a split is not made
Programmer