Brother BAS-761 Instruction Manual page 28

5. Input the stitch length, then press
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
6. Move the needle with
when the needle point is at point B of the
pattern.
7. Repeat step 6 and create the program to
point E.
8. When point E is programmed, press
again.
Point E becomes a corner and is programmed. To change the
stitch length, press
9. Create the program to point I.
10. When point I is programmed, press
again.
11. Press twice.
ESC ESC
2
Inputting the end code
1. Select with
2. Press .
Press and the needle returns to the first stitch(point A).
3. Press .
ESC ESC
The needle returns to the standby position.
. Press
for resetting.
ESC ESC
, then press
.
.
Programmer
Chapter 2 Programming with Help Function
27