Brother BAS-761 Instruction Manual page 154

23. Repeat step 22 and create the program to point
S.
24. Move the needle with
7 8 9 L
of the pattern.
Point N is programmed tos be a corner.
25. Press .
M
26. Repeat step 22 and create the program to point
Y.
27. Press .
LI LI
28. Move the needle with
the needle point is at point Z of the pattern.
29. Press
9
9 is a command for needle tacking. Input the stitch length
in . 0.5 mm is input in the example.
30. Move the needle with
the needle point is at point A of the pattern.
2
Input the end code
1. Press
1 1
The needle goes back to the sewing start position and the retractable
clamp is positioned outside.
when the needle point is at point T
. Press
, then press .
LI LI
. Press
.
1 E
. Press
when
L
when
L
Programmer
Chapter 5 Practical programming examples
153