Stac Parameters - Bay Networks CLAM Reference Manual

Issue 1
Nautica Configuration Wizard Reference Guide
Parameter:
Default:
Options:
Function:
Instructions:
Note:
not run with the Any value.

Stac Parameters

If you choose StacLZ as your compression type, then this
parameter needs to be set.
Parameter:
Default:
Options:
Function:
Instructions:
8-20
Type
Any
MPPC, StacLZ, WCP, Any, None
Determines the compression used over this path
The default value here is MPPC. Select the type of
compression you want to use on this path. Set the
parameter to None if compression is not supported, or
select Any if you are unsure.
• MPPC: Microsoft Point to Point Compression.
• StacLZ: Compression algorithm developed by Stac
Electronics.
• WCP: WAN Compression Protocol as used by
many BayRS routers.
• Any: Any of the above (apart from WCP) is
negotiated in order of priority: MPPC then StacLZ.
WCP is only used when it is specified by itself. It does
Checkmode
Disabled
Sequenced, Extended, NoCheck
If StacLZ is selected as the compression type, a
checkmode (error correction) must also be selected here.
The three values are as follows:
118814-A Rev. A