The routing parameters are grouped and explained in the
following paragraphs.
RIP Parameters
The RIP parameters allow you to specify how RIP will be used
across this path.
Parameter:
Default:
Options:
Function:
Instructions:
Parameter:
Default:
Options:
Function:
Instructions:
118814-A Rev. A
IP RIP Protocol
None
Rip1 Compatible, Rip1, Rip2, Rip1 Subset, None
This parameter specifies the IP protocol that will be used
over this path.
For more information,
Path"
on
page
8-3.
IP RIP Direction
Both Way
Both Way, Block All, Send Only, Listen Only
This parameter specifies the way IP will move along this
path.
For more information on IP RIP direction, refer to
"Editing a Path" on
Configuring Paths
refer to "Editing the LAN01
page
8-3.
Issue 1
8-17