Ppp -I; New Admin/Na Parameters In R14.1.9 - Bay Networks 5399 Release Note

New admin/na Parameters in R14.1.9

• Ctrl-p - Display the previous CLI command, up to the 25th.
• Ctrl-n - Display the succeeding CLI command, if there is
one (otherwise, nothing is displayed).
Ctrl-p and Ctrl-n work without a <CR>; use them to scroll backward
and forward through the command history.

ppp -i

The -i argument now may be used with the ppp command. This argument
displays the locally configured local and remote addresses.
Four configuration parameters have been added.
In Release 14.1.9, these parameters can be accessed through
the admin utility only.
Two parameters have been added to the Annex category to enable the
RAC to negotiate the addresses of the primary and secondary NetBIOS
name servers (per RFC 1877):
• pref_nbns1_addr - The IP address of the primary NetBIOS
name server. The default value is 0.0.0.0.
• pref_nbns2_addr - The IP address of the secondary
NetBIOS name server. The default value is 0.0.0.0.
Two parameters have been added to the Security category to enable an
administrator to change the prompts for RADIUS user and RADIUS
password. These prompts are used only when auth_protocol is set to
radius, and are not used for local authentication, or when auth_protocol
is set to acp.
Remote Access Software Version 5.3 Release Notes
300115-B Rev. A
33