Connecting And Disconnecting Units; Figure 15-6. Connect & Disconnect Buttons - Bay Networks CLAM Reference Manual

Issue 1
Nautica Configuration Wizard Reference Guide
If you are sending information over a WAN, then details on this
data can be seen here. On the left of the screen you can see what
the destination of the data is and also the type of path the data is
being sent over (PPP for a Nautica 200).
In the centre of the screen are the two percentage utilisation bars
for transmitted and received data. To the right of these are four
LEDS.
The first two LEDs tell you if the data is being sent synchronous
or asynchronous. Beneath these is an LED that will illuminate if
there is an error on the WAN. If compression has been turned off
then the Compression Off LED will be on, otherwise the ration of
compression for transmitted data is displayed beneath the
Compression Off LED.
At the bottom of the WAN element is a small status bar reminding
you that the unit is currently connected and also what the current
time is.

Connecting and Disconnecting Units

To disconnect the current unit from NauticaWatch:
•
or
•
.
Figure 15-6.
To connect to another unit:
•
or
•
15-6
Click on the Disconnect button (red cross)
Select Disconnect from the Device menu
Connect & Disconnect Buttons
Click on the Connect button (green tick)
Select Connect from the Device menu
118814-A Rev. A