Bootp Relay - Bay Networks CLAM Reference Manual

Issue 1
Nautica Configuration Wizard Reference Guide
Table 8-1.
Modifier
!
#
$
F

BOOTP Relay

BOOTP Relay allows non-IP information to be routed across your
Nautica unit. If BOOTP Relay information is to be passed along
this path, then you must enable this parameter.
Parameter:
Default:
Options:
Function:
8-12
Other modifiers that can be entered before telephone
numbers are shown in
ISDN Telephone Number Modifiers
Description
V120 Calls
56k Calls
Modem Calls
Fax Calls
If PPTP has been enabled in the System settings
7-7), then the first number here needs to be set up as the
IP address of the originator of the PPTP tunnel, or the
Terminator of the tunnel. The following syntax must be
used:
u192.1.1.25
Enable
Disabled
Disabled, Enabled
If this path is used to pass BOOTP Relay information
then you must select the Enable option. BOOTP Relay
must also be turned on in the System window
Table 8-1.
118814-A Rev. A
(page
(page 7-5).