Effects Controller Numbers - Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual

Effects

Effects Controller Numbers

Effects Controller Numbers
The K2vx uses the Digitech 256 chip for its effects processor. When in Program Mode, the
operating system allows you to assign any MIDI controller to Wet/Dry Mix plus two additional
parameters related to the effect. (The choice of controllable parameters changes depending on
the effect conÞguration. They are the parameters you see when you go to edit the effect.)
But if the FX Mode parameter on the Effects page is set to Master, then the remapping that takes
place within the program is not applied. Instead, you use a predeÞned set of controller
numbers. So to control the effects processor in real time when FX Mode is set to Master, you
must use the following controller numbers.
To control the effects processor in this manner, press the EFFECTS button. Change FX Mode to
Master, and set FX Chan to the channel you will use to send the controller info. (You can also
send program changes on this channel to switch effects, so it is usually best to pick a channel
that is not being used for notes.) These settings are remembered as long as the Power Mode
parameter on the MIDI receive page is set to User. Otherwise, you will have to re-enter the
settings each time you power up.
In the following chart, the parameters are grouped by ConÞguration. Multi FX will contain
parameters found in more than one conÞguration.
Ultimate Reverb
Decay time
Room volume
HF damping
Envelopment
Early Delay
Early Diffusion
Later Delay
Later Diffusion
Dry Level
Early Level
Later Level
Room Simulation
Gross Size
Decay Time
Listening Position
HF Damping
Dry Level
Reverb Level
Reverb in Multi FX
RevPre-Delay
Hi-Freq Damp
Reverb Decay
Revin dry
Revin ßange
Revin Delay
22-2
77
78
14
32
29
30
n/a
93
28
31
92
90
15
79
14
28
88
80
83
82
86
87
85