Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual page 19

NOTE: You can perform a quick check of the K2vxR and your audio system without a MIDI
controller connected to the K2vxR. Hold down the CANCEL button on the alphanumeric pad
and press any other alphanumeric button, and you should hear notes. See "The Panel Play
Feature" in Chapter 3 for more information about this feature.
L R
A
SCSI Thru
KDS Output
In Out Optical Out
Digital
SCSI In
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Connecting SCSI
You may not have a hard disk or other SCSI device to connect to your K2vx right away, but if
you do, you can connect it to either of the SCSI ports. Please read the following information
carefully; itÕs very important.
IMPORTANT NOTE: If you plan to connect more than one SCSI device to the K2vx (including
an Apple Macintosh Ò ), you must terminate your SCSI chain properly. Turn to Chapter 13 and
read the section called ÒSCSI Termination.Ó You can lose data, and possibly damage your K2vx
and SCSI devices if theyÕre not terminated properly.
Switching On the Power
The power switch is located at the lower left of the front panel. When you power up, the
display will brießy say ÒWelcome to the K2vx!Ó The Program Mode display will then appear. It
looks like the diagram below (the programs shown in the diagram donÕt necessarily exist):
ProgramMode||||Xpose:0ST|||<>Channel:1||
!!!!!!!!!!!!!!!!!!@ |198|Analog|Jam||||||
KeyMap|Info||||||| # | 199|Default|Program|
| Grand|Piano||||| | # | ||1|Righteous|Piano|
|||||||||||||||||| # |||2|Mondo|Bass||||||
|||||||||||||||||| # |||3|Killer|Drums||||
%%%%%%^%%%%%%^%%%%$ | | |4|Wee p ing|Gu i tar||
Octav- | Octav+ | Panic| | View|| | Chan-| | Chan+
Set the volume at a comfortable level. YouÕll get the best signal-to-noise ratio if you keep the
K2vx at full volume (turn the volume knob fully clockwise), and adjust the level from your
mixing board. You may also want to adjust the display contrast. This is done with the Contrast
parameter in Master mode. See Chapter 11. As you trigger notes from your MIDI controller,
youÕll see the MIDI LED ßash. If it doesnÕt ßash, check your MIDI cables and connections.
L R L R L
B C
Audio Outs
MIDI Select
Thru / Out Out Thru / Out
MIDI
Mfr:
Young Chang Akki, Co., LTD
R L R
D Mix
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION:
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
WARNING:
TO REDUCE RISK OF FIRE OF ELECTRIC
SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR
MOISTURE. WARNING:
AGAINST THE RISK OF FIRE, REPLACE ONLY
WITH SAME TYPE AND RATING OF FUSE.
ATTENTION:
Serial No.
Made in Korea RECHANGE DE MEME TYPE.
The Rear Panel
Power
FOR CONTINUED PROTECTION 100/120V ~ T 2.00A 250V SLOW-BLOW
220/240V ~ T 1.00A 250V SLOW-BLOW
100/120/220/240V ~ AC
1.5/0.75A
UTILISER UN FUSIBLE DE
48-65HZ
Batteries
Startup
2-3