The Setup Editor - Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual

Setup Mode and the Setup Editor

The Setup Editor

The Setup Editor
Press the EDIT button to enter the Setup Editor, and you can make changes to the currently
selected setup. The Setup Editor page looks like this:
EditSetup||||||||||||||||||||<>Zone:1|||
Program: ||1|Grand|Piano||| |ModWhl:MWheel
Channel:1|||||Mode|:Both|||FtSw1|:Sustai
XPose||:0ST|||PBend:On|||||FtSw2|:SostPd
LoKey||:C|0|||PChng:On|||||CPedal:Foot||
HiKey||:G|9|||FXMix:48%Wet|Slider:Data||
Effect | :1|Swe e t|Hall | 2||||| P ress|: MPress
Name|| | Save|| | Delete | Dump|| | SetRng |V:127
The upper line gives you the usual mode reminder, and shows you which zone is currently
selected. Use the CHAN/BANK buttons to select different zones. Each of the three zones in a
setup has its own page identical to the one shown above. Zones can overlap if you want, but
they donÕt have to. If you have other MIDI devices connected to the K2vxÕs MIDI Out port, you
should always use different MIDI channels for each zone. You can get to the Program Editor
from the Setup editor by pressing EDIT when the Program parameter is selected. This gives
you access to the other editors nested within the Program Editor, as well.
Setup Editor Parameters
The parameters on the Setup Editor page deÞne what each of a setupÕs zones sends to the MIDI
Out port. They also determine how the K2vx responds to MIDI signals received from a MIDI
controller connected to the K2vxÕs MIDI In port (when the Local Keyboard Channel matches
the transmit channel of your MIDI controller). TheyÕre in effect only when youÕre in Setup
mode, however, so although they override the corresponding parameters on the MIDI mode
XMIT page, they donÕt actually change those settings. The MIDI mode settings resume control
when you exit Setup mode.
Note: Only the Program, Effect, and Effects Mix parameters will function as programmed if the
Local Keyboard Channel does not match the transmit channel of your MIDI controller. When
they are set to the same channel, the remaining parameters will take effect as well.
PARAMETER
PROGRAM
CHANNEL
TRANSPOSE
LOW KEY
HIGH KEY
EFFECT
EFFECTS MIX
MODE
PITCH BEND
PROGRAM CHANGE
MOD WHEEL
FOOT SWITCH 1
FOOT SWITCH 2
CONTROL PEDAL
CONTROL SLIDER
MONO PRESSURE
V
7-2
RANGE OF VALUES
Program list
Off, 1 to 16
± 60 semitones
C –1 to G 9
C –1 to G 9
Preset Effects list
0 to 100% wet
Off, Both, MIDI, Local
Off, On
Off, On
MIDI Control Source list
MIDI Control Source list
MIDI Control Source list
MIDI Control Source list
MIDI Control Source list
MIDI Control Source list
Off, 1-127