Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual page 461

LFO
Layer
Leslie effect
Local
Memory banks
MIDI
MIDI device
MIDI Master
MIDI Slave
Non-linear
DSP Function
Note State
Object
Low frequency oscillator. An oscillator is an electrical signal that cycles regularly
between a minimum and maximum amplitude. The simplest oscillating waveform is
the sine wave, but an LFO waveform can have almost any shape. The number of times
each second that an oscillator repeats itself is called its frequency, which is measured
in Hertz (Hz). Anything up to 50 Hz is considered low-frequency in musical
applications. Use an LFO whenever you want to generate a periodic (repeating) effect.
Adjusting the rate of the LFO will change the repetition rate of the effect.
A layer consists of a keymap processed through an algorithm. Layers can be stacked
together within a program. Each layer uses one of the K2vxÕs 48 available voices. Each
K2vx program can contain up to three layersÑexcept drum channel programs, which
can contain up to 32 layers.
This classic vibrato effect was originally created by mounting a speaker in its cabinet
so the speaker could be rotated at varying speeds. This applied a vibrato of varying
rate to all sounds played through the rotating speaker.
In this manual, used primarily in reference to control sources. A local control source
affects each note in a layer independently. For example, if a local LFO is used as a
control source, a separate LFO cycle will begin with each note start. The LFOs donÕt
run in phase unless notes are started simultaneously. Compare Global.
The K2vxÕs memory is divided into ten spaces where you can store any object you
edit. These spaces are called banks. Each bank can hold up to 100 objects of each type,
so we refer to them as the 100s bank, the 200s bank, and so on. The ID of an object
determines which bank itÕs stored in. An object with an ID of 399, for example, would
be stored in the 300s bank. ROM objects are stored in the Zeros and 100s banks. RAM
objects can be stored in any bank.
Musical Instrument Digital Interface. A specialized format for representing musical
information in terms of standardized computer data, which enables electronic musical
instruments to communicate with computers
Any deviceÑkeyboard, computer, wind instrument, etc.Ñwhich is capable of
transmitting and receiving MIDI messages.
A MIDI device that is conÞgured to control one or more other MIDI devices. The
MIDI Out port of the master is connected by cable to the MIDI In port(s) of the slave
device(s).
A MIDI device that is conÞgured to receive MIDI messages from a master device. The
MIDI In port of the slave is connected by cable to the MIDI Out port of the master.
Without getting technical, non-linear DSP functions like SHAPER and WRAP add
waveforms to those already present in a sound, while linear DSP functions act upon
the existing waveforms without adding new ones.
Any K2vx note is either on or off; this is its note state. Normally, any given noteÕs Note
State switches on when you strike the key for that note. It switches off when you
release the key, and any sustain controls you may have applied to the note (Sustain or
Sostenuto pedal, etc.). Also see the index entry for Note State.
A chunk of information stored in the K2vxÕs memory. Programs, setups, keymaps,
and samples are all objects. There are several others as well. Also see the index entry
for ÒObjects.Ó
Glossary
31-3