Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual page 333

18 Mix Echo
F:MixEcho||||Start:0.000||||End:2.048|||
Tempo:120|Start:0||#:4||VolAdj:0dB||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
This function operates much like Mix Beat, but instead of the Beat and Of parameters, you have
Start and Ò#Ó parameters. The Start parameter sets the beat at which the selected Sample 2
segment begins being mixed with the selected Sample 1 segment. Sample 2 is repeated on every
beat after this starting point. The Ò#Ó parameter determines how many times the Sample 2
segment is repeated.
The Volume Adjust parameter will affect the volume of each repetition of Sample 2. It sets the
relative level of the last beat, and boosts or cuts each repetition by a proportionate amount from
the starting level. This is a linear adjustment, measured in decibels, evenly spaced over the total
number of mixed-in beats.
If you set the Ò#Ó parameter to a positive value, the adjustment in volume begins on the second
mixed-in beat (the Þrst beat plays at the initial level). If you set a negative value, the Þrst mix of
Sample 2 will be cut or boosted by the Vol adjust amount.
19 Beat Volume Adjust
F:BeatVolAdj|Start:0.000||||End:2.048|||
Tempo:120|Beat:1||Of:1||VolAdj:0dB||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
This function works much like Mix Beat. The difference is that youÕre not mixing in any
samples, youÕre just volume adjusting Sample 1 at regular intervals. Each beat is adjusted in
volume by the amount speciÞed for the VolAdj parameter. This is useful for mixing part of a
sample within itself.
Set the Start and End positions of Sample 2 to deÞne the length of time over which the volume
will be adjusted. For example, if you had a six-second sample, and you set the Tempo to 120,
the Beat parameter to 1, and the Of parameter to 1, youÕd have twelve beats deÞned. If you then
set the range of Sample 2 at a half-second, and set the VolAdj parameter to -3 dB, then youÕll
insert 12 volume adjustments into Sample 1, each lasting a half second, and bringing the level
down 3 dB.
Sampling and Sample Editing
Editing Samples
15-29