Kurzweil K2000 - MUSICIANS GUIDE Musician's Manual page 62

Program Mode and the Program Editor
The Program Editor—Pages
This parameter is similar to the Src1 and Depth parameters on the F4 AMP page, but the
attenuation curve for the Crossfade parameter is optimized speciÞcally for crossfades.
To crossfade two layers in the same program, assign the same control source for the CrossFade
parameters in both layers, then set one of their XFadeSense parameters to a value of Norm, and
the otherÕs to Rvrs.
Other OUTPUT Page Configurations
The following page is for a layer with one keymap and a double-output algorithm. The U and L
stand for the upper and lower wires (signal paths). You have independent control of the output
parameters for each wire.
EditProg:OUTPUT||||||||||||<>Layer:1/1||
||||||||||||||||||||||||||||||||||||||||
||Pair:||Pan:||||||||||||||Mode:||Gain:|
U:A(FX)||L||||||||||||||*R|+MIDI||6dB|||
L:A(FX)||L*||||||||||||||R|+MIDI||6dB|||
||||||||||||||||||||||||||||||||||||||||
CrossFade|:OFF||||||XFadeSense:Norm|||||
<more||OUTPUT|EFFECT|COMMON|SetRng|more>
Next are the two page conÞgurations for layers with stereo keymaps: the Þrst one uses a single-
output algorithm, and the second uses a double-output algorithm.
With a single-output algorithm, stereo keymap layers let you adjust the pan position of each
keymap, but all other parameters are identical for both keymaps.
EditProg:OUTPUT||||||||||||<>Layer:1/1||
Pair:A(FX)||||||||||||||||||||||||||||||
Pan1:L*||||||||||||||R||||||||||||||||||
Pan2:L||||||||||||||*R||||||||||||||||||
Mode:+MIDI||||||||||||||||||||||||||||||
Gain:6dB||||||||||||||||||||||||||||||||
CrossFade|:OFF||||||XFadeSense:Norm|||||
<more||OUTPUT|EFFECT|COMMON|SetRng|more>
When a stereo keymap layer uses a double-output algorithm, both keymaps are split between
the upper and lower wires. In other words, both wires carry the signal from each of the
keymaps. The Output Group (Pair), Output mode, and Gain level of Keymap 1 are mimicked
by Keymap 2 (thatÕs why these parameters arenÕt displayed for Keymap 2 on the OUTPUT
page). You can, however, set the pan positions independently for the upper and lower wires of
both keymaps.
EditProg:OUTPUT||||||||||||<>Layer:1/1||
|||Pair:||Pan:||||||||||||||Mode:|Gain:|
U1:A(FX)||L*||||||||||||||R|+MIDI|6dB|||
L1:A(FX)||L||||||||||||||*R|+MIDI|6dB|||
U2:|||||||L||||||||||||||*R|||||||||||||
L2:|||||||L*||||||||||||||R|||||||||||||
CrossFade|:OFF||||||XFadeSense:Norm|||||
<more||OUTPUT|EFFECT|COMMON|SetRng|more>
6-20